How To Open Hp 2000 Laptop To Clean Fan

In this post I explain how to disassemble HP 2000. I will remove main laptop components and show how to admission area under the height cover.

I'll go through the post-obit major disassembly steps:
Footstep 1-vii: Accessing RAM. Removing the difficult drive and DVD drive.
Step 8-15: Disconnecting and removing the keyboard.
Footstep 16-19: Removing the top encompass assembly. Accessing the internal components.

Before you showtime the disassembly process make sure the calculator turned off.

STEP one.

Unlock and remove the bombardment.

STEP 2.

Remove one screw securing the memory embrace.

Elevator up and remove the cover.

Under this cover you can access both memory slots and wireless carte. It's not necessary to remove them for the purpose of my disassembly and then I'll exit them continued to the motherboard.

Step iii.

Remove one spiral securing the hard drive cover.

Lift upward and remove the cover.

Step iv.

Remove four screws securing the hard bulldoze mounting bracket to the base.

Stride 5.

Disconnect the hard drive cable from the motherboard.

Simply lift upward the connector by the black belt located on the acme of the connector.

STEP 6.

If yous are replacing or upgrading the difficult drive you'll have to disconnect the cable and mounting bracket.

The mounting subclass secured by 4 screws (two on each side).

Transfer the bracket and cablevision to the new hard drive.

Pace 7.

Remove one screw securing the DVD drive.

Pull DVD bulldoze to the left and remove information technology.

STEP 8.

Remove 1 spiral securing the keyboard. This screw is located shut to the wireless card.

STEP 9.

The keyboard is secured to the superlative cover past five latches.

Pace 10.

Push on the left latch with a small screwdriver and at the same time elevator up the keyboard a little bit so the latch doesn't lock dorsum in place.

While lifting up the left side of the keyboard, button on the next latch and and then on.

Stride 11.

Afterward you unlock all latches yous should be able to lift upwards the top side of the keyboard.

Be conscientious, the keyboard still attached to the motherboard.

STEP 12.

Plow the keyboard upside downward and identify it on the palmrest.

Now you can access the keyboard connector. In the next two steps I explicate how to unlock the connector and release the keyboard cable.

Pace 13.

The keyboard connector has a moving function – dark-brown locking tab.

Carefully lift up the left side of the tab with your fingernail. It will open upward at a ninety degree bending.

STEP 14.

On this moving-picture show the connector shown in the unlocked position.

Now you can pull cable from the connector.

STEP xv.

Lift up and remove the keyboard.

Stride 16.

Remove all screws from the bottom.

STEP 17.

Remove one screw securing the acme comprehend assembly.

Disconnect three cables (from left to correct):
– Ability button cable.
– Touchpad push button lath cablevision.
– Touchpad cable.

Pace xviii.

Start separating the top cover assembly from the lesser cover.

You can utilise a slice of soft plastic (I'm using the guitar selection) for that. Insert it between the summit cover and lesser cover and move along the side.